Nissan Versa (N17): Fuel filler lid lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Fuel filler lid lock

FUEL FILLER LID LOCK : Removal and Installation

REMOVAL

1. Fully open fuel filler lid.

2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation".

3. Release pawls (A) and remove fuel filler lid lock assembly (1) from opening.

CAUTION: Be careful not to damage gasket (2) when removing.

REMOVAL

4. Disconnect fuel filler lid opener cable (1) by pulling downward and then sliding cable end to the side to remove from fuel filler lid lock assembly (2).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, check fuel filler lid assembly open/close, lock/unlock operation.

Fuel filler opener cable

FUEL FILLER OPENER CABLE : Removal and Installation REMOVAL 1. Remove hood and fuel filler handle assembly bolts (A). 2. Disconnect fuel filler lid opener cable (2) by pulling downward and th ...

Door switch

Exploded View 1. Door switch 2. Door switch bolt Removal and Installation REMOVAL 1. Remove the door switch bolt (A). 2. Disconnect the harness connector and remove door switch (1). INST ...

Other materials:

Fuel pressure check
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform "FUEL PRESSURE RELEASE" in "WORK SUPPORT" mode with CONSULT. Start engine. After engine stalls, crank it two or three times to release all fuel pressure. Turn ignition switc ...

Front wheel hub and knuckle
Inspection Check the axle and suspension parts for excessive play, wear, or damage. Shake each front wheel to check for excessive play as shown. FRONT WHEEL BEARING INSPECTION Move wheel hub and bearing assembly in the axial direction by hand. Make sure the axial end play is withi ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0084