WHEN BOTH POWER WINDOW MAIN SWITCH AND REAR POWER WINDOW SWITCH RH ARE OPERATED : Diagnosis Procedure
1.CHECK REAR POWER WINDOW SWITCH RH
Check rear power window switch RH.
Refer to PWC "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK REAR POWER WINDOW MOTOR RH
Check rear power window motor RH.
Refer to PWC "REAR RH : Component Function Check".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES >> Check intermittent incident. Refer to GI "Intermittent Incident".
NO >> GO TO 1
WHEN REAR POWER WINDOW SWITCH RH IS OPERATED : Diagnosis Procedure
1.CHECK REAR POWER WINDOW SWITCH RH POWER SUPPLY AND GROUND CIRCUIT
Check rear power window switch RH power supply and ground circuit.
Refer to PWC "REAR POWER WINDOW SWITCH : Diagnosis Procedure".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK REAR POWER WINDOW SWITCH RH
Check rear power window switch RH.
Refer to PWC "Component Function Check".
Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace the malfunctioning parts.
3.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES >> Check intermittent incident. Refer to GI "Intermittent Incident".
NO >> GO TO 1.
WHEN POWER WINDOW MAIN SWITCH IS OPERATED : Diagnosis Procedure
1.CHECK REAR POWER WINDOW SWITCH RH
Check rear power window switch RH.
Refer to PWC "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES >> Check intermittent incident. Refer to GI "Intermittent Incident".
NO >> GO TO 1.
AUTO OPERATION DOES NOT OPERATE BUT MANUAL OPERATE NORMALLY (DRIVER SIDE)
Diagnosis Procedure
1.REPLACE POWER WINDOW MAIN SWITCH
Replace power window main switch.
>> Refer to PWC "Removal and Installation".
POWER WINDOW RETAINED POWER OPERATION DOES NOT OPERATE PROPERLY
Diagnosis Procedure
1. CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to PWC "Component Inspection".
Is the inspection result normal?
YES >> Check intermittent incident. Refer to GI "Intermittent Incident".
NO >> Repair or replace the malfunctioning parts.
POWER WINDOW LOCK SWITCH DOES NOT FUNCTION
Diagnosis Procedure
1.REPLACE POWER WINDOW MAIN SWITCH
Replace power window main switch.
>> Refer to PWC "Removal and Installation".
REMOVAL AND INSTALLATION
Removal and Installation REMOVAL 1. Remove main power window and door lock/unlock switch finisher assembly using a suitable tool (A). Pawl 2. Disconnect the harness connector from the main pow ...
Multiport fuel injection system
MULTIPORT FUEL INJECTION SYSTEM : System Diagram
MULTIPORT FUEL INJECTION SYSTEM : System
Description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*4
Piston position
Fuel injection & ...
Front drive shaft
Exploded View
1. Drive shaft 2. Cotter pin A. Apply Molykote M77
Removal and Installation
REMOVAL
Remove the wheel and tire assembly using power tool. Refer to WT
"Adjustment".
Remove wheel sensor and sensor harness. Refer to BRC "FRONT WHEEL SENSOR
: Removal and
...