Nissan Versa (N17): B1209 - B1210 Collision detection

Description

DTC B1209 - B1210 COLLISION DETECTION

The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a frontal or side deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.

PART LOCATION

Refer to SRC "Component Parts Location".

DTC Logic

DTC DETECTION LOGIC

With CONSULT   

CONSULT name

DTC

DTC detecting condition

Repair order

FRONTAL COLLISION DETECTION B1209 Driver and/or front passenger air bag modules are deployed. Refer to SR "For Frontal Collision".
SIDE COLLISION DETECTION B1210 Side and/or curtain air bag modules are deployed. Refer to SR "For Side and Rollover Collision".

DTC CONFIRMATION PROCEDURE (With CONSULT)

1.INSPECTION START

Turn ignition switch ON.

>> GO TO 2.

2.CHECK SELF-DIAG RESULT

Check for the DTC on CONSULT.

Is the DTC detected?

YES >> Refer to SRC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Refer to SR "For Frontal Collision" or SR "For Side and Rollover Collision".

SYMPTOM DIAGNOSIS

B1017, B1018, B1020, B1021, B1022, B1025, B1032, B1048 OCS System

Description DTC B1017, B1018, B1020, B1021, B1022, B1025, B1032, B1048 OCCUPANT CLASSIFICATION SYSTEM (OCS) The OCS control unit is wired to the air bag diagnosis sensor unit. The air bag diag ...

SRS Air bag warning lamp does not turn on

AIR BAG Warning Lamp Does Not Turn On 1.CHECK METER FUSE Check the 10A fuse [No. 3, located in the fuse block (J/B)]. Is the fuse blown? YES >> GO TO 2 NO >> GO TO 3 2.REPLACE METER ...

Other materials:

P1715 Input speed sensor
Description ECM receives input speed sensor signal from TCM via the CAN communication line. ECM uses this signal for engine control. DTC Logic DTC DETECTION LOGIC NOTE: If DTC P1715 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX. If DTC P1715 is displa ...

P0973 Shift solenoid A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0973 Shift Solenoid "A" Control Circuit Low The following diagnosis conditions are met, and the TCM select switch ON-OFF solenoid valve monitor value is ON c ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0105