U1000 CAN COMM
DTC Logic
DTC DETECTION LOGIC
NOTE: U1000 can be set if a module harness was disconnected and
reconnected, perhaps during a repair. Confirm that there are actual CAN
diagnostic symptoms and a present DTC by performing the Self Diagnostic Result
procedure.   ...
Push-button ignition switch
Removal and Installation
REMOVAL
1. Remove NATS antenna amp. Refer to SEC "Removal and Installation".
2. Release the push-button ignition switch pawls and remove the
push-button ignition switch (1).
: Pawl
INSTALLATION
Installation is in the reverse order of removal. ...