Nissan Versa (N17): Seat belt warning system

Seat Belt Warning System Does Not Function

1.SEAT BELT WARNING LIGHT

Turn ignition switch ON.

Does the seat belt warning lamp come ON?

YES >> GO TO 2

NO >>

  • Check 10A fuse [No. 3, located in the fuse block (J/B)].
  • Check seat belt buckle switch LH.
  • Check harness between combination meter and seat belt buckle switch LH.
  • Check combination meter. Refer to MWI "Fail-Safe" (with Type A Meter) or MWI "Fail- Safe" (with Type B Meter).

2.SEAT BELT BUCKLE LH

Fasten the seat belt buckle LH.

Does the seat belt warning lamp go OFF?

YES >> GO TO 3

NO >>

  • Check seat belt buckle switch LH.
  • Check harness between combination meter and seat belt buckle switch LH.

3.OCCUPANT CLASSIFICATION SYSTEM

Have a helper sit in the passenger seat.

Does the seat belt warning lamp go ON?

YES >> GO TO 4

NO >>

  • Check occupant classification system. Refer to SRC "OCCUPANT CLASSIFICATION SYSTEM : System Description".
  • Check harness between occupant classification control unit and air bag diagnosis sensor unit.

4.SEAT BELT BUCKLE RH

Fasten the seat belt buckle RH.

Does the seat belt warning lamp go OFF?

YES >> System OK.

NO >>

  • Check seat belt buckle switch RH.
  • Check harness between seat belt buckle switch RH and air bag diagnosis sensor unit.
  • Replace air bag diagnosis sensor unit. Refer to SR "Removal and Installation".

SRS Air bag warning lamp does not turn off

AIR BAG Warning Lamp Does Not Turn Off 1.CHECK CONDITION OF AIR BAG MODULE Inspect for any deployed air bag modules or seat belt pre-tensioners. Are any air bag modules or seat belt pre-tensioners ...

Other materials:

Parking brake
WARNING Be sure the parking brake is fully released before driving. Failure to do so can cause brake failure and lead to an accident. Do not release the parking brake from outside the vehicle. Do not use the shift lever in place of the parking brake. When parking, be sure the par ...

P073E Unable to engage r range
Description This malfunction is detected when the A/T does not shift into reverse position as instructed by TCM. This is not only caused by electrical malfunction (circuits open or shorted) but by mechanical malfunction such as control valve sticking, improper solenoid valve operation, etc D ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.006