Nissan Versa (N17): Combination meter buzzer

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Combination meter buzzer

Component Function Check

1.CHECK FUNCTION

  1. Select INTELLIGENT KEY of BCM using CONSULT.
  2. Select INSIDE BUZZER in ACTIVE TEST mode.
  3. Touch Key, Knob or Take Out to check that it works normally.

Is the inspection result normal?

Yes >> Combination meter buzzer is OK.

No >> Refer to DLK "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK METER BUZZER CIRCUIT

Refer to WCS "Component Function Check".

Is the inspection result normal?

Yes >> GO TO 2.

No >> Repair or replace harness.

2.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

Power supply and ground circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown.&nb ...

Other materials:

Low tire pressure warning lamp does not turn off
Diagnosis Procedure 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace damaged parts. 2.BCM POWER SUPPLY AND GROUND CIRCUITS ...

Hood lock
HOOD LOCK : Removal and Installation REMOVAL Remove hood lock assembly bolts and hood lock assembly. Disconnect hood lock control cable assembly (2) from hood lock assembly (1). INSTALLATION Installation is in the reverse order of removal. CAUTION: Be careful not to bend the cabl ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0055