Nissan Versa (N17): P0605 ECM

DTC Logic

DTC DETECTION LOGIC

DTC No. Trouble diagnosis name DTC detecting condition Possible cause

P0605

Engine control module A ECM calculation function is malfunctioning. ECM
B ECM EEP-ROM system is malfunctioning.
C ECM self shut-off function is malfunctioning.

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A

  1. Turn ignition switch ON.
  2. Check 1st trip DTC.

Is 1st trip DTC detected?

YES >> Go to EC, "Diagnosis Procedure".

NO >> GO TO 3.

3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B

  1. Turn ignition switch ON and wait at least 1 second.
  2. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
  3. Check 1st trip DTC.

Is 1st trip DTC detected?

YES >> Go to EC, "Diagnosis Procedure".

NO >> GO TO 4.

4.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C

  1. Turn ignition switch ON and wait at least 1 second.
  2. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
  3. Repeat step 2 for 32 times.
  4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES >> Go to EC, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

  1. Erase DTC.
  2. Perform DTC CONFIRMATION PROCEDURE.
  3. See EC, "DTC Logic".

Is the 1st trip DTC P0605 displayed again?

YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

  1. Replace ECM. Refer to EC, "Removal and Installation".
  2. Perform EC, "Work Procedure".

>> INSPECTION END

P0603 ECM power supply

Description ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is ...

P0607 ECM

DTC Logic DTC DETECTION LOGIC DTC No. Trouble diagnosis (Trouble diagnosis content) DTC detecting condition Possible cause P0607 ECM (CAN communication bus) ...

Other materials:

Instrument panel
1. Headlight/turn signal switch/fog light switch (if so equipped) 2. Driver's supplemental air bag (P. 1-39) Horn 3. Meters and gauges. Warning and indicator lights 4. Wiper and washer switch 5. Vents 6. Rear window defroster switch 7. Front passenger air bag status light 8. Hazard warn ...

Fluid cooler tube
Exploded View 1. Fluid cooler tube A 2. Copper sealing washer 3. Fluid cooler tube B 4. Bolt 5. Transaxle assembly Removal and Installation WARNING: Do not open the radiator cap or drain plug when the engine is hot. There is a danger that hot liquid may spray out, causing serious in ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0097