Nissan Versa (N17): Evaporative emission system

Nissan Versa 2nd generation (N17) Service Manual / Engine / Engine control system (EC) / Evaporative emission system

Inspection

1.CHECK EVAP CANISTER

  1. Block port (B).
  2. Blow air into port (A) and check that it flows freely out of port (C).
  3. Release blocked port (B).
  4. Apply vacuum pressure to port (B) and check that vacuum pressure exists at the ports (A) and (C).
  5. Block port (A) and (B).
  6. Apply pressure to port (C) and check that there is no leakage.

CHECK EVAP CANISTER

>> INSPECTION END

Ignition timing

Inspection 1.CHECK IGNITION TIMING     1.   Attach timing light (A) to loop wire (1) as shown.     2.   Check ignition timing. 1 : Timing in ...

EVAP leak check

Inspection CAUTION: Do not use compressed air or a high pressure pump. Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: Do not start engine. Improp ...

Other materials:

Timing chain
Exploded View 1. Timing chain slack guide 2. Timing chain tensioner 3. Camshaft sprocket (EXH) 4. Camshaft sprocket (INT) 5. Plug 6. Front oil seal 7. Crankshaft pulley 8. Crankshaft pulley bolt 9. Front cover 10. Crankshaft sprocket 11. Crankshaft sprocket key 12. Oil pump sprocket 13. O ...

Engine stand setting
Setting NOTE: The following procedures explain how to disassemble the engine with the engine stand fastened to the bell housing. Some steps may be different if using a different type of engine stand.     1.   Install engine to engine stand:     a. Rem ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0162