Nissan Versa (N17): Ignition timing

Inspection

1.CHECK IGNITION TIMING

    1.   Attach timing light (A) to loop wire (1) as shown.

CHECK IGNITION TIMING

    2.   Check ignition timing.

1 : Timing indicator

>> INSPECTION END

CHECK IGNITION TIMING

IDLE SPEED

Inspection 1.CHECK IDLE SPEED With CONSULT Check idle speed in "DATA MONITOR" mode with CONSULT. Without CONSULT Check idle speed by installing the pulse type tachometer clamp on the loop wir ...

Evaporative emission system

Inspection 1.CHECK EVAP CANISTER Block port (B). Blow air into port (A) and check that it flows freely out of port (C). Release blocked port (B). Apply vacuum pressure to port (B) and check ...

Other materials:

Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the VDC system on for most driving conditions. If the vehicle is stuck in mud or snow, the VDC system reduces the engine output to reduce wheel spin. The engine speed will be reduced even if the accelerator is depressed to the floor. If maximum engine po ...

Noise, vibration and harshness (NVH) troubleshooting
NVH troubleshooting Chart Locate the area where noise occurs. Confirm the type of noise. Specify the operating condition of engine. Check specified noise source If necessary, repair or replace these parts. Location of noise Type of noise Operating condition of ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0086