Exploded View
1. Door switch 2. Door switch bolt
Removal and Installation
REMOVAL
1. Remove the door switch bolt (A).
2. Disconnect the harness connector from door switch (1) and remove.
INSTALLATION
Installation is in the reverse order of removal.
FUEL FILLER LID LOCK : Removal and Installation REMOVAL 1. Fully open fuel filler lid. 2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation". ...
Removal and Installation REMOVAL 1. Remove the glove box. Refer to IP "Removal and Installation". 2. Remove the remote keyless entry receiver bolt (A). 3. Disconnect the harness connec ...
If your vehicle overheats
If your vehicle is overheating (indicated by an
extremely high temperature gauge reading (if so
equipped), a red high temperature warning light
(if so equipped) ), or if you feel a
lack of
engine power, detect abnormal noise, etc. take
the following steps.
WARNING
Do not continue to driv ...
Intake valve timing control
Intake valve timing control : System Diagram
Intake valve timing control : system description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Engine speed*1
Piston position
Intake valve timing
con ...