U1000 CAN Comm circuit
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.CHECK DTC DETECTION
With CONSULT.
Turn ignition switch ON.
Perform self diagnostic result.
Is DTC U1000 detected?
YES >> Proceed to diagnosis procedure. Refer to LAN "Trouble Diagnosis Flow
Chart".
NO >> Ref ...
U1000 CAN COMM
DTC Logic
DTC DETECTION LOGIC
NOTE: U1000 can be set if a module harness was disconnected and
reconnected, perhaps during a repair. Confirm that there are actual CAN
diagnostic symptoms and a present DTC by performing the Self Diagnostic Result
procedure.   ...