Drive belt idler pulley
Exploded View
1. Generator bracket 2. Center shaft 3. Spacer
4. Adjusting bolt 5. Washer 6. Idler pulley
7. Plate
Removal and Installation
REMOVAL
Remove the fender protector (RH).
Remove the air duct inlet assembly.
Remove drive belt.
Remove the lock nut, and then remove the pl ...
Output speed sensor
Exploded View
1. Transaxle assembly 2. Output speed sensor 3. O-ring
Front Genuine
NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
Disconnect the harness connector from output speed sensor.
NOTE:
Lift up the vehicle and perform the work from rear of the transaxle
asse ...