
WARNING
CAUTION
When adjusting the seat positions, be sure not to contact any moving parts to avoid possible injuries and/or damage.
Your vehicle seats can be adjusted manually. For additional information about adjusting the seats, refer to the steps outlined in this section.
Forward and backward

Pull the lever up and hold it while you slide the seat forward or backward to the desired position.
Release the lever to lock the seat in position.
Reclining

To recline the seatback, pull the lever up and lean back. To bring the seatback forward, pull the lever up and lean your body forward. Release the lever to lock the seatback in position.
The reclining feature allows adjustment of the seatback for occupants of different sizes for added comfort and to help obtain proper seat belt fit. For additional information, refer to "Precautions on seat belt usage" in this section. Also, the seatback can be reclined to allow occupants to rest when the vehicle is stopped and the shift lever is in P (Park) or N (Neutral) position with the parking brake fully applied.
Seat lifter (if so equipped for driver's seat)

Move the adjusting lever as shown to adjust the seat height until the desired position is achieved.

WARNING
If they are not completely secured, passengers may be injured in an accident or sudden stop.
Armrest (if so equipped for driver's side only)

To use the armrest, pull it down to the resting position.
Engine compartment check locationsHR16DE Engine 1. Drive belt location 2. Engine oil filler cap 3. Air cleaner 4. Brake and clutch (if so equipped) fluid reservoir 5. Fusible link 6. Battery 7. Engine coolant reservoir 8. ...

WARNING Head restraints/headrests supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions. Adjustable head restraints/hea ...
U0155 Lost communication (IPC)
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
U0155
Lost Communication With Instrument
Panel Cluster (IPC)
Control Module
When the ignition switch is ON,
TCM is unable to receive the
CAN communications ...
P0706 Transmission range sensor A
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0706
Transmission Range Sensor
"A" Circuit Range/Performance
The following diagnosis conditions
are met and the position
signal is OFF continuously for
15 ...