Nissan Versa (N17): Front fender

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Front fender

FRONT FENDER : Removal and Installation

CAUTION: Use a shop cloths to protect the body from being damaged during removal and installation.

REMOVAL

  1. Remove fender protector. Refer to EXT "Removal and Installation".
  2. Remove front bumper fascia and bumper side bracket. Refer to EXT "Removal and Installation".
  3. Remove front combination lamp. Refer to EX "Removal and Installation".
  4. Remove front door corner finisher. Refer to MIR "FRONT DOOR CORNER FINISHER : Removal and Installation".
  5. Remove front fender cover. Refer to DLK "FENDER COVER : Removal and Installation".
  6. Remove front fender bolts from front fender.
  7. Remove front fender stiffener (2) while carefully pulling upper portion of front fender (1) away from body.

: Front

REMOVAL

    8.   Remove front fender.

CAUTION:

A viscous urethane foam is installed on the back surface of front fender. When removing the front fender, be careful to not deform the front fender while performing the procedure and removing the viscous urethane foam a little at a time.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Adjust the following components as necessary.
  • Hood assembly: Refer to DLK "HOOD ASSEMBLY : Adjustment".
  • Front door assembly: Refer to DLK "DOOR ASSEMBLY : Adjustment".
  • After adjusting, apply touch-up paint (body color) onto the head of the front fender bolts.

Radiator core support lower

RADIATOR CORE SUPPORT LOWER : Removal and Installation Removal 1. Remove under cover. Refer to EXT "Removal and Installation". 2. Remove radiator upper seal clips. 3. Remove front bumpe ...

Fender cover

FENDER COVER : Removal and Installation REMOVAL Fully open hood assembly. Disengage pawls beginning at the front of the fender cover and working toward the rear of vehicle and then remove f ...

Other materials:

Precautions
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and ...

Front wheel hub and knuckle
Inspection Check the axle and suspension parts for excessive play, wear, or damage. Shake each front wheel to check for excessive play as shown. FRONT WHEEL BEARING INSPECTION Move wheel hub and bearing assembly in the axial direction by hand. Make sure the axial end play is withi ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0096