Nissan Versa (N17): Front wheel hub and knuckle

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Front axle (FAX) / Front wheel hub and knuckle

Inspection

  • Check the axle and suspension parts for excessive play, wear, or damage.
  • Shake each front wheel to check for excessive play as shown.

Inspection

FRONT WHEEL BEARING INSPECTION

  • Move wheel hub and bearing assembly in the axial direction by hand. Make sure the axial end play is within specification.

Axial end play : Refer to FAX "Wheel Bearing".

  • Check that the wheel hub bearing operates smoothly.
  • Replace the wheel hub assembly if the axial end play exceeds specification, or if the wheel bearing does not turn smoothly. Refer to FAX "Removal and Installation".

CAUTION: The wheel hub assembly does not require maintenance. If any of the following symptoms are noted, replace the wheel hub assembly.

  • Growling noise is emitted from the wheel hub bearing during operation.
  • Wheel hub bearing drags or turns roughly.

FRONT DRIVE SHAFT

Inspection

  • Check drive shaft mounting point and joint for looseness and other damage.
  • Check boot for cracks and other damage. Replace or repair components as necessary. Refer to FAX "Removal and Installation", FAX "Disassembly and Assembly".

    CAUTION: Replace entire drive shaft assembly when noise or vibration occur from drive shaft.

REMOVAL AND INSTALLATION

Precautions

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", us ...

Front wheel hub and knuckle

Exploded View 1. Steering knuckle 2. Splash guard 3. Wheel bearing 4. Snap ring 5. Wheel stud 6. Wheel hub 7. Disc rotor 8. Cotter pin A. Apply Molykote M77 ...

Other materials:

Fuel level sensor unit, fuel filter and fuel pump assembly
Exploded View 1. Lock ring 2. Fuel level sensor unit, fuel filter and fuel pump assembly 3. O-ring 4. Fuel tank Removal and Installation WARNING: Be sure to read "General Precautions" before working on the fuel system. Refer to FL, "General Precautions". REMOVAL Release t ...

Brake pad
BRAKE PAD : Inspection and Adjustment INSPECTION Check brake pad wear thickness from an inspection hole on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR "Front Disc Brake". ADJUSTMENT Burnish contact surfaces between disc rotor and brake pads a ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0231