Nissan Versa (N17): Rear pillar finisher

Nissan Versa 2nd generation (N17) Service Manual / Body interior / Interior (INT) / Rear pillar finisher

REAR PILLAR FINISHER : Removal and Installation

REMOVAL

  1. Partially remove rear body side welt. Refer to INT "BODY SIDE WELT : Removal and Installation".
  2. Remove rear seat cushion. Refer to SE "Removal and Installation - Seat Cushion Assembly".
  3. Remove the rear seat bolster. Refer to SE "Removal and Installation - Rear Seat Bolster".
  4. Release rear pillar finisher clips and metal clips using a suitable tool (A) and remove rear pillar finisher by pulling outward.

: Clip

: Metal clip

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: When installing rear pillar finisher, make sure that clips and metal clips are securely pressed in body holes.

Center pillar upper finisher

CENTER PILLAR UPPER FINISHER : Removal and Installation REMOVAL Remove front shoulder anchor. Refer to SB "SEAT BELT RETRACTOR : Removal and Installation". Remove front body side ...

Rear parcel shelf finisher

Exploded View 1. High-mounted stop lamp 2. Rear parcel shelf finisher 3. Seat belt finisher 4. Seatback latch cover 5. Top tether strap anchor 6. Top tether strap anchor finisher Front Paw ...

Other materials:

Doors
When the doors are locked using one of the following methods, the doors cannot be opened using the inside or outside door handles. The doors must be unlocked to open the doors. WARNING Before opening any door, always look for and avoid oncoming traffic. To help avoid risk of injury or de ...

Hood
1. Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly. 2. Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips. 3. Raise the hood 3 . 4. Remove the support rod and insert it into the ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0076