CENTER PILLAR UPPER FINISHER : Removal and Installation
REMOVAL
WARNING: Do not reuse center pillar upper finisher if removed.
CAUTION: When releasing molded in pawls, follow the steps as shown to prevent finisher or clip damage.
4. Release center pillar upper finisher lower pawl using a suitable tool (A) and remove center pillar upper finisher.
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: When installing center pillar upper finisher, make sure that pawls and are securely pressed into the body panel holes.
BODY SIDE WELT : Removal and Installation CAUTION: Do not excessively pull or stretch body side welts. FRONT BODY SIDE WELT Removal Remove dash side finisher. Refer to INT "DASH SIDE FI ...
REAR PILLAR FINISHER : Removal and Installation REMOVAL Partially remove rear body side welt. Refer to INT "BODY SIDE WELT : Removal and Installation". Remove rear seat cushion. Re ...
Air cleaner and air duct
Exploded View
1. Clamp 2. PCV hose 3. Clamp
4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body
7. Grommet 8. Air cleaner filter 9. Air cleaner cover
10. Mass air flow sensor 11. Air duct 12. Clamp
Removal and Installation
REMOVAL
NOTE:
Mass air flow sensor is removable as an assemb ...
Final drive
Exploded View
1. Differential side bearing outer race 2. Differential side bearing 3. Final
drive
: Replace the parts as a set.
Disassembly
Remove differential side bearings, using Tool (A) and suitable tool.
Tool number : ST33052000 ( - )
Assembly
Install differential sid ...