Nissan Versa (N17): Body side welt

Nissan Versa 2nd generation (N17) Service Manual / Body interior / Interior (INT) / Body side welt

BODY SIDE WELT : Removal and Installation

CAUTION: Do not excessively pull or stretch body side welts.

FRONT BODY SIDE WELT

Removal

  1. Remove dash side finisher. Refer to INT "DASH SIDE FINISHER : Removal and Installation".
  2. Remove center pillar lower finisher. Refer to INT "CENTER PILLAR LOWER FINISHER : Removal and Installation".
  3. Remove front body side welt.

Installation

Installation is in the reverse order of removal.

REAR BODY SIDE WELT

Removal

  1. Remove center pillar lower finisher. Refer to INT"CENTER PILLAR LOWER FINISHER : Removal and Installation".
  2. Remove rear body side welt.

Installation

Installation is in the reverse order of removal.

CENTER PILLAR LOWER FINISHER

CENTER PILLAR LOWER FINISHER : Removal and Installation

REMOVAL

  1. Remove front kicking plate and rear kicking plate. Refer to INT "KICKING PLATE INNER : Removal and Installation".
  2. Remove center pillar lower finisher as shown.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Dash side finisher

DASH SIDE FINISHER : Removal and Installation REMOVAL Remove front kicking plate. Refer to INT "KICKING PLATE INNER : Removal and Installation". Lift up rear end of dash side finis ...

Center pillar upper finisher

CENTER PILLAR UPPER FINISHER : Removal and Installation REMOVAL Remove front shoulder anchor. Refer to SB "SEAT BELT RETRACTOR : Removal and Installation". Remove front body side ...

Other materials:

Break-in schedule
CAUTION During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in shortened engine life and reduced engine performance. ...

Stall test
Work Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU "Inspection". Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80C (122 to 176F). Inspect the amount of ATF. Replenish ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0057