TransmitterExploded View 1. Transmitter (tire pressure sensor) 2. O-ring 3. Valve stem nut 4. Valve core 5. Valve cap 6. Valve stem assembly : Parts that are replaced as a set when the tire is replaced ...
Torsion bar
TORSION BAR : Removal and Installation
REMOVAL
1. Remove torsion bar clamp.
2. Support trunk lid with a suitable tool.
WARNING:
Bodily injury may occur if trunk lid is not supported properly when removing the
torsion bars.
3. Apply a torsion bar wrench (A) to torsion bar (1) and lift torsi ...
Inside handle
INSIDE HANDLE : Removal and Installation
REMOVAL
1. Remove rear door finisher. Refer to INT "Removal and Installation".
2. Remove upper side of sealing screen.
NOTE:
Cut the butyl tape so that some parts of the butyl tape remain on the sealing
screen, if the sealing screen
is reuse ...