Nissan Versa (N17): Map lamp

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Interior lighting system (INL) / Map lamp

Exploded View

Exploded View

1. Map lamp bulb housing 2. Bulb 3. Lens Pawl

Removal and Installation

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION: Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.

REMOVAL

1. Release lens pawls using suitable tool (A) and remove.

CAUTION: Apply protect tape (B) on suitable tool (A).

: Pawl

REMOVAL

2. Release map lamp housing pawl using suitable tool (A).

CAUTION: Apply protect tape (B) on suitable tool (A).

: Pawl

3. Disconnect the harness connector from map lamp and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Bulb Replacement

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION:

  • Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
  • Leaving the bulb removed from housing for a long period of time can deteriorate performance of the lens and reflector (causing dirt or clouding). Always prepare a new bulb and have it on hand when replacing the bulb.

MAP LAMP BULB

Removal

1. Release lens pawls using suitable tool (A) and remove.

CAUTION: Apply protect tape (B) on suitable tool (A).

Pawl

Removal

2. Remove the bulb.

Installation

Installation is in the reverse order of removal.

Push-button ignition switch illumination circuit

Description Provides the power supply and the ground to control the push-button ignition switch illumination. ...

Interior room lamp

Other materials:

Component inspection
Inspection AFTER A COLLISION WARNING: Inspect all seat belt assemblies including retractors and attaching hardware after any collision. NISSAN/INFINITI recommends that all seat belt assemblies in use during a collision be replaced unless the collision was minor and the belts show no dam ...

Front pillar finisher
FRONT PILLAR FINISHER : Removal and Installation REMOVAL Release front pillar portion of front body side welt. Pull front pillar finisher downward as shown, using mild pressure to disengage the front pillar finisher from the clips. : Clip     3.   Remove the f ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0097