Nissan Versa (N17): Console lamp

Removal and Installation

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION: Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.

REMOVAL

1. Remove the center console assembly. Refer to IP "Removal and Installation".

2. Rotate shift selector lamp assembly (1) counter-clockwise and remove.

Front

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Bulb Replacement

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION:

  • Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
  • Leaving the bulb removed from housing for a long period of time can deteriorate performance of the lens and reflector (causing dirt or clouding). Always prepare a new bulb and have it on hand when replacing the bulb.

SHIFT SELECTOR LAMP BULB

Removal

1. Remove shift selector lamp. Refer to IP "Removal and Installation".

2. Pull shift selector bulb from bulb socket (1).

Front

REMOVAL

Installation

Installation is in the reverse order of removal.

Trunk room lamp

Exploded View 1. Trunk room lamp 2. Bulb Front Pawl ...

Other materials:

Wiper and washer switch
Switch operation Type A (if so equipped) The windshield wiper and washer operates when the ignition switch is in the ON position. Push the lever down to operate the wiper at the following speed: Intermittent (INT) - intermittent operation can be adjusted by turning the knob toward ...

Sensor rotor
FRONT SENSOR ROTOR FRONT SENSOR ROTOR : Removal and Installation REMOVAL The front wheel sensor rotor is an integral part of the wheel hub and bearing assembly and can not be replaced individually. When replacing the front wheel sensor rotor replace the hub and bearing assembly. Refer to ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0112