Exploded View

1. Trunk room lamp 2. Bulb Front
Pawl
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION:
REMOVAL
1. Release the trunk room lamp pawl to open lens.
: Pawl

2. Remove the bulb.
3. Release trunk room lamp pawl with a suitable tool (A)
Pawl
Front
4. Disconnect harness connector from trunk room lamp and remove.

INSTALLATION
Installation is in the reverse order of removal.
WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.
CAUTION:
TRUNK ROOM LAMP BULB
Removal
1. Release the trunk room lamp pawl to open lens.
Pawl

2. Remove the bulb.
Installation
Installation is in the reverse order of removal.
ILLUMINATION CONTROL SWITCH
Removal and Installation
The illumination control switch is integrated in the combination meter. Refer to MWI "Removal and Installation" (TYPE A) or MWI "Removal and Installation" (TYPE B).
SERVICE DATA AND SPECIFICATIONS (SDS)
Bulb Specifications
*: Always check with the Parts Department for the latest parts info.

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as "AIR BAG" and "SEAT BELT PRE-TENSIONER", us ...
O/D OFF indicator lamp
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YES >> INSPECTION END
NO >> Go to TM "Diagnosis Procedure".
Diagnosis Procedur ...
Output speed sensor
Exploded View
1. Output speed sensor 2. O-ring 3. Transaxle assembly
Front
Removal and Installation
REMOVAL
Remove the front LH wheel and tire.
Disconnect the harness connector from output speed sensor.
Remove the output speed sensor.
Remove the O-ring from the output speed sens ...