DTC Logic
DTC DETECTION LOGIC 
Diagnosis Procedure
1.CHECK DTC DETECTION
With CONSULT.
1. Turn ignition switch OFF to ON.
2. Perform self diagnostic result.
Is DTC U1000 detected?
YES >> Proceed to diagnosis procedure. Refer to LAN "Trouble Diagnosis Flow Chart".
NO >> Refer to GI "Intermittent Incident".
U1010 CONTROL UNIT (CAN)
Description
Initial diagnosis of combination meter.
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.REPLACE COMBINATION METER
Replace combination meter. Refer to MWI"Removal and Installation".
>> Inspection End.
Diagnosis and repair workflowWork Flow OVERALL SEQUENCE DETAILED FLOW 1.CONFIRM SYMPTOM Confirm symptom or customer complaint. >> GO TO 2 2.SELF-DIAGNOSIS OF COMBINATION METER Perform self-diagnosis of combinat ...

Description The ABS actuator and electric unit (control unit) provides a vehicle speed signal to the combination meter via CAN communication lines. DTC Logic &n ...
Air cleaner and air duct
Exploded View
1. Clamp 2. PCV hose 3. Clamp
4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body
7. Grommet 8. Air cleaner filter 9. Air cleaner cover
10. Mass air flow sensor 11. Air duct 12. Clamp
Removal and Installation
REMOVAL
NOTE:
Mass air flow sensor is removable as an assemb ...
Component parts
Component Parts Location
1. Condenser 2. Compressor 3. Refrigerant pressure sensor
4. Liquid tank 5. Evaporator 6. Expansion valve
A. Built-in heater & cooling unit assembly
Component Description
Component
Description
Evaporator
The mist form liquid refrigerant t ...