Nissan Versa (N17): Bluetooth control unit

Nissan Versa 2nd generation (N17) Service Manual / Driver information & multimedia / Audio, visual & navigation system (AV) / Bluetooth control unit

Removal and Installation

REMOVAL

1. Remove the trunk floor finisher.

2. Remove the trunk rear finisher.

3. Remove the trunk side finisher (RH)

4. Disconnect the harness connector (A) from Bluetooth antenna.

5. Disconnect the harness connector (B) from Bluetooth control unit.

REMOVAL

6. Remove the Bluetooth control unit screws (C) and the Bluetooth control unit (1).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Bluetooth antenna

Removal and Installation REMOVAL 1. Remove the rear seat cushion assembly. Refer to SE "Removal and Installation - Seat Cushion Assembly". 2. Remove the rear step plate (RH). 3. Rem ...

Microphone

Removal and Installation 1. Remove the microphone (1) from the headlining using a suitable tool. Clip 2. Disconnect the harness connector from microphone and remove. INSTALLATION Installation ...

Other materials:

Spark plugs
Replacing spark plugs Platinum-tipped spark plugs It is not necessary to replace platinum-tipped A spark plugs as frequently as conventional type spark plugs because they last much longer. Follow the maintenance log shown in the Maintenance and Schedules section of this manual. Do not ser ...

Main power supply and ground circuit
Diagnosis Procedure 1.CHECK TCM POWER CIRCUIT 1 Turn the ignition switch OFF. Disconnect the TCM connector. Check the voltage between the TCM harness connector terminals and ground. Is the inspection result normal? YES >> GO TO 2. NO >> GO TO 4. 2.CHECK TCM POWER ...

Nissan Versa (N17): Bluetooth control unit

Bluetooth antenna

Microphone

Other materials:

Categories