Removal and Installation
REMOVAL
1. Disconnect the negative battery terminal. Refer to PG "Removal and Installation".
2. Remove cluster lid A. Refer to IP "Removal and Installation".
3. Remove the combination meter screws.
4. Pull the combination meter straight out to disengage resin clips.
NOTE: The illustration shows the clip positions on the back of the combination meter.

5. Disconnect the harness connector from the combination meter and remove.
INSTALLATION
Installation is in the reverse order of removal.
UNIT DISASSEMBLY AND ASSEMBLY
The low washer fluid warning continues
displaying, or does not displayDescription The warning is still displayed even after washer fluid is added. The warning is not displayed even though the washer tank is empty. Diagnosis Procedure 1.CHECK WASHER FLUID L ...

Exploded View 1. Unified meter control unit 2. Front cover Disassembly and Assembly DISASSEMBLY 1. Disengage the tabs to separate front cover using a suitable tool. 2. Pull the front cover st ...
TCM
Exploded View
1. TCM 2. Bracket 3. Clip Front
Removal and Installation
CAUTION:
When replacing TCM, note the "CVTF DETERIORATION DATE" value displayed on
CONSULT "CONFORM
CVTF DETERIORTN" in MAINTENANCE BOOKLET, before starting the operation.
NOTE:
When replacing the TCM and transaxle ...
Front stabilizer
Exploded View
1. Stabilizer bar 2. Stabilizer clamp 3. Stabilizer bushing
4. Stabilizer connecting rod 5. Strut assembly 6. Front suspension member
Front
Removal and Installation
REMOVAL
Remove wheel and tire assemblies using power tool. Refer to WT
"Adjustment".
Remove ...