Nissan Versa (N17): Combination meter buzzer

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Combination meter buzzer

Component Function Check

1.CHECK FUNCTION

Select INTELLIGENT KEY of BCM using CONSULT.
Select INSIDE BUZZER in ACTIVE TEST mode.
Touch Key, Knob or Take Out to check that it works normally.

Is the inspection result normal?

Yes >> Combination meter buzzer is OK.

No >> Refer to DLK "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK METER BUZZER CIRCUIT

Refer to WCS "Component Function Check".

Is the inspection result normal?

Yes >> GO TO 2.

No >> Repair or replace harness.

2.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

>> Inspection End.

Power supply and ground circuit

Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS "Wiring Diagram". 1.CHECK FUSES AND FUSIBLE LINK Check that the following fuses and fusible link are not blown.&nb ...

Door lock actuator

Other materials:

Brakes
If the brakes do not operate properly, have the brakes checked. It is recommended that you visit a NISSAN dealer for this service. Self-adjusting brakes Your vehicle is equipped with self-adjusting brakes. The front disc-type brakes self-adjust every time the brake pedal is applied. The rea ...

U1000 CAN COMM
DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by performing the Self Diagnostic Result procedure. ...

Nissan Versa (N17): Combination meter buzzer

Power supply and ground circuit

Door lock actuator

Other materials:

Categories