Description
Detects trunk open/close condition.
Component Function Check
1.CHECK FUNCTION
With CONSULT
Check TRNK/HAT MNTR in Data Monitor mode with CONSULT.

Is the inspection result normal?
YES >> Trunk room lamp switch is OK.
NO >> Refer to DLK "Diagnosis Procedure".
Regarding Wiring Diagram information, refer to DLK "INTELLIGENT KEY SYSTEM : Wiring Diagram".
1.CHECK TRUNK ROOM LAMP SWITCH INPUT SIGNAL

Is the inspection result normal?
YES >> GO TO 6
NO >> GO TO 2
2.CHECK TRUNK ROOM LAMP SWITCH CIRCUIT


Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace harness between BCM and trunk room lamp switch.
3.CHECK TRUNK ROOM LAMP SWITCH GROUND CIRCUIT
Check continuity between trunk room lamp switch connector and ground.

Is the inspection result normal?
YES >> GO TO 4
NO >> Repair or replace trunk room lamp switch ground circuit.
4.CHECK BCM OUTPUT SIGNAL

Is the inspection result normal?
YES >> GO TO 5
NO >> Replace BCM. Refer to BCS "Removal and Installation".
5.CHECK TRUNK ROOM LAMP SWITCH
Refer to DLK "Component Inspection".
Is the inspection result normal?
YES >> GO TO 6
NO >> Replace trunk room lamp switch.
6.CHECK INTERMITTENT INCIDENT
Refer to GI "Intermittent Incident".
>> Inspection End.
1.CHECK TRUNK ROOM LAMP SWITCH

Is the inspection result normal?
YES >> Inspection End.
NO >> Replace trunk room lamp switch.
SYMPTOM DIAGNOSIS
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
the tire sidewall between tread shoulder and
maximum section width. For example:
Treadwear 200 ...
Performance test
Inspection
INSPECTION PROCEDURE
Connect recovery/recycling/recharging equipment (for HFC-134a) or
manifold gauge.
Start the engine, and set to the following condition.
Test condition &n ...