DTC DETECTION LOGIC
NOTE:
Refer to BCS "DTC Logic".
Refer to BCS "DTC Logic".

1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON.
2. Check DTC in Self Diagnostic Result mode of ENGINE using CONSULT.
Is DTC detected?
YES >> Go to SEC "Diagnosis Procedure".
NO >> Inspection End.
1.REPLACE BCM
1. Replace BCM. Refer to BCS "Removal and Installation".
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.
Does the engine start?
YES >> Inspection End.
NO >> GO TO 2.
2.REPLACE ECM
1. Replace ECM. Refer to EC "Removal and Installation".
2. Perform "ADDITIONAL SERVICE WHEN REPLACING ECM". Refer to EC "Work Procedure".
>> Inspection End.
P073E Unable to engage r range
Description
This malfunction is detected when the A/T does not shift into reverse
position as instructed by TCM. This is not
only caused by electrical malfunction (circuits open or shorted) but by
mechanical malfunction such as control
valve sticking, improper solenoid valve operation, etc
D ...
Side air bag (satellite) sensor
Removal and Installation
Side air bag (satellite) sensor
1. Side air bag (satellite) sensor harness slide
double locking type connector Front
Front door (satellite) sensor
1. Front door (satellite) sensor harness
connector
2. Front door (satellite) sensor A. Front door (satellit ...