Nissan Versa (N17): B260F Engine status

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B260F Engine status

Description

BCM receives the engine status signal from ECM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  • If DTC B260F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS "DTC Logic".
  • If DTC B260F is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS "DTC Logic".           

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON and wait 2 seconds or more.

2. Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Select Self Diagnostic Result mode of BCM using CONSULT.

3. Touch ERASE.

4. Perform DTC CONFIRMATION PROCEDURE for DTC B260F. Refer to SEC "DTC Logic".

Is DTC detected?

YES >> GO TO 2.

NO >> Inspection End.

2.REPLACE ECM

1. Replace ECM.

Refer to EC "Removal and Installation".

2. Perform "ADDITIONAL SERVICE WHEN REPLACING ECM".

Refer to EC "Work Procedure".

>> Inspection End.

Other materials:

Drive belt
1. Water pump pulley 2. Generator pulley 3. Manual tensioner pulley 4. Air conditioner compressor pulley 5. Crankshaft pulley WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. 1. Visually inspect t ...

O/D OFF indicator lamp
Component Function Check 1.CHECK O/D OFF INDICATOR LAMP FUNCTION Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON. Is the inspection results normal? YES >> INSPECTION END NO >> Go to TM "Diagnosis Procedure". Diagnosis Procedur ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0087