Nissan Versa (N17): B2616 Ignition relay circuit

Nissan Versa 2nd generation (N17) Service Manual / Electrical & power control / Power control system (PCS) / B2616 Ignition relay circuit

DTC Logic

DTC DETECTION LOGIC               

DTC CONFIRMATION PROCEDURE

1. PERFORM SELF DIAGNOSTIC RESULT

1. Turn ignition switch ON under the following conditions, and wait for at least 1 second.

  • CVT selector lever is in the P (park) or N (neutral) position.
  • Release brake pedal

2. Perform self diagnostic result.

Is DTC B2616 detected?

YES >> Refer to PCS "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to PCS "Wiring Diagram".

1. CHECK IGNITION RELAY-2 POWER SUPPLY CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect BCM connector M98.

3. Check continuity between ignition relay-2 connector J-3 terminal 1 and BCM connector M98 terminal 99.

4. Check continuity between ignition relay-2 connector J-3 terminal 1 and ground.

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace harness or connectors.

2. CHECK IGNITION RELAY-2 GROUND CIRCUIT

1. Check continuity between ignition relay-2 connector J-3 terminal 2 and ground.

Is the inspection result normal?

YES >> GO TO 3.

NO >> Repair or replace harness or connectors.

3. CHECK IGNITION RELAY-2

Perform the relay component inspection. Refer to PCS "Component Inspection".

Is the inspection result normal?

YES >> GO TO 4.

NO >> Replace ignition relay-2.

4. CHECK IGNITION RELAY-2 POWER SUPPLY (BCM)

Check voltage between BCM connector M98 terminal 99 and ground.

Is the inspection result normal?

YES >> Refer to GI "Intermittent Incident".

NO >> Replace BCM. Refer to BCS "Removal and Installation".

Component Inspection

1.CHECK IGNITION RELAY

1. Turn ignition switch OFF.

2. Remove ignition relay.

3. Check the continuity between ignition relay terminals.                   

CHECK IGNITION RELAY

Is the inspection result normal?

YES >> Inspection End.

NO >> Replace ignition relay

Other materials:

Shift position indicator circuit
Component Parts Function Inspection 1.CHECK SHIFT POSITION INDICATOR Start the engine. Shift the selector lever. Check that the selector lever position and the shift position indicator on the combination meter are identical. Is the inspection result normal? YES >> INSPECTION ...

P0965 Pressure control solenoid B
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0965 Pressure control solenoid B control circuit range performance The detection conditions continuously for 5 seconds or more under the following diagnosis con ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0083