DTC DETECTION LOGIC
NOTE:

DTC CONFIRMATION PROCEDURE
1. PERFORM SELF DIAGNOSTIC RESULT
1. Turn ignition switch ON under the following conditions, and wait for at least 1 second.
2. Perform self diagnostic result.
Is DTC B2618 detected?
YES >> Refer to PCS "Diagnosis Procedure".
NO >> Inspection End.
Regarding Wiring Diagram information, refer to PCS "Wiring Diagram".
1.CHECK IGNITION RELAY-1 CONTROL SIGNAL
Check voltage between BCM harness connector and ground.

Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> GO TO 2.
2.CHECK IGNITION RELAY-1 CONTROL SIGNAL CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect BCM connector and IPDM E/R.
3. Check continuity between BCM harness connector and IPDM E/R harness
connector.
4. Check continuity between BCM harness connector and ground.

Is the inspection result normal?
YES >> GO TO 3.
NO >> Repair or replace harness.
3.CHECK VOLTAGE OF IGNITION RELAY-1 CONTROL SIGNAL CIRCUIT (IPDM E/R SIDE)
1. Connect IPDM E/R connector.
2. Check voltage between IPDM E/R harness connector and ground.
Is the inspection result normal?
YES >> Replace BCM. Refer to BCS "Removal and Installation".
NO >> Replace IPDM E/R.
Engine protection control at low engine oil pressure
Engine protection control at low engine oil pressure : system diagram
Engine protection control at low engine
oil pressure : system description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Engine oil pressure sensor
Engine pressure
...
Air mix door cable
AIR MIX DOOR CABLE : Removal and Installation
REMOVAL
Remove foot duct (LH). Refer to VTL "FOOT DUCT : Removal and
Installation".
Disconnect air mix door cable from A/C control.
Disconnect air mix door cable from A/C unit assembly, and then remove
air mix door cable.
INST ...