Nissan Versa (N17): P0966 Pressure control solenoid B

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P0966 Pressure control solenoid B

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P0966 Pressure control solenoid B control circuit low The primary pressure solenoid valve current is 200 mA or less continuously for 480 msec or more under the following diagnosis conditions:

- Diagnosis conditions

- Solenoid valve output current: 750 mA or more

- GND short circuit diagnosis occurs in the solenoid valve drive circuit.

- TCM power supply voltage: More than 11 V

 - Harness or connector (Primary pressure solenoid valve circuit shorted to ground)

- Primary pressure solenoid valve

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine and wait for 5 seconds or more.
  2. Check the first trip DTC.

Is "P0966" detected?

YES >> Go to TM "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT

  1. Turn ignition switch OFF.
  2. Disconnect TCM connector and CVT unit connector.
  3. Check continuity between TCM harness connector terminal and ground. 

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace malfunctioning parts.

2.CHECK PRIMARY PRESSURE SOLENOID VALVE

Check primary pressure solenoid valve. Refer to TM "Component Inspection (Primary Pressure Solenoid Valve)".

Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI "Intermittent Incident".

NO >> Repair or replace malfunctioning parts.

Component Inspection (Primary Pressure Solenoid Valve)

1.CHECK PRIMARY PRESSURE SOLENOID VALVE

Check resistance between CVT unit connector terminal and ground. 

Is the inspection result normal?

YES >> INSPECTION END

NO >> There is a malfunction of primary pressure solenoid valve. Replace transaxle assembly. Refer to TM "Removal and Installation".

P0965 Pressure control solenoid B

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0965 Pressure control solenoid B control circuit range performance ...

P0967 Pressure control solenoid B

Other materials:

CVT Control system
Symptom Table The diagnosis item number indicates the order of check. Start checking in the order from 1. Symptom diagnosis chart 1-1 Symptom diagnosis chart 1-2 Symptom diagnosis chart 2-1 Symptom diagnosis chart 2-2 PERIODIC MAINTENANCE ...

Blower fan resistor
Exploded View 1. A/C unit assembly 2. Blower motor 3. Blower fan resistor Removal and Installation REMOVAL Remove instrument panel assembly. Refer to IP "Removal and Installation". Disconnect harness connector from the blower fan resistor. Remove screws and blower fan res ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0093