Nissan Versa (N17): P0965 Pressure control solenoid B

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / P0965 Pressure control solenoid B

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P0965 Pressure control solenoid B control circuit range performance The detection conditions continuously for 5 seconds or more under the following diagnosis conditions:

- Diagnosis conditions

- Selector lever: Other than "P" and "N" positions

- Auxiliary gearbox shifting is not in progress.

- Engine speed: More than 500 rpm

- Detection condition A

- Actual primary pulley ratio: 2.0 - 2.4

- Target primary pulley ratio: Less than 1.2

- Detection condition B

- Actual primary pulley ratio: 0.35 - 0.75

- Target primary pulley ratio: More than 1.55

 Primary pressure solenoid valve

DTC CONFIRMATION PROCEDURE

CAUTION:

  • Be sure to perform "TM "Diagnosis Procedure"" and then perform "DTC CONFIRMATION PROCEDURE".
  • Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary malfunction.
  • Be careful of the driving speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Drive the vehicle.
  3. Maintain the following conditions for 20 seconds or more.
  4. Stop the vehicle.
  5. Check the first trip DTC

Vehicle speed : 20 km/h (13 MPH) or more

Is "P0965"detected?

YES >> Go to TM "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDENT

Refer to GI "Intermittent Incident".

Is the inspection result normal?

YES >> Replace transaxle assembly. Refer to TM "Removal and Installation".

NO >> Repair or replace malfunctioning parts.

P0963 Pressure control solenoid A

P0966 Pressure control solenoid B

Other materials:

Component parts
Component Parts Location 1. Condenser 2. Compressor 3. Refrigerant pressure sensor 4. Liquid tank 5. Evaporator 6. Expansion valve A. Built-in heater & cooling unit assembly Component Description Component Description Evaporator The mist form liquid refrigerant t ...

Fender cover
FENDER COVER : Removal and Installation REMOVAL 1. Fully open hood assembly. 2. Disengage pawls beginning at the front of the fender cover and working toward the rear of vehicle and then remove front fender cover. CAUTION: When performing the procedure after removing fender cover, protect th ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0105