Nissan Versa (N17): Fender cover

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Fender cover

FENDER COVER : Removal and Installation

REMOVAL

1. Fully open hood assembly.

2. Disengage pawls beginning at the front of the fender cover and working toward the rear of vehicle and then remove front fender cover.

CAUTION: When performing the procedure after removing fender cover, protect the lower windshield glass with urethane etc.

: Pawl

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

For installation, engage pawls to front fender and cowl top cover in numerical order shown.
Install so that there is no clearance between windshield and cowl top cover.

INSTALLATION

FRONT DOOR

Exploded View

Exploded View

1. Front door assembly 2. Grommet 3. Striker bolt 4. Door striker 5. Bumper rubber 6. Door check link 7. Door hinge (lower) 8. Door hinge (upper) 9. Grommet (Driver side only)

Front fender

FRONT FENDER : Removal and Installation CAUTION: Use a shop cloths to protect the body from being damaged during removal and installation. REMOVAL Remove fender protector. Refer to EXT " ...

Other materials:

Drive belt
1. Water pump pulley 2. Generator pulley 3. Manual tensioner pulley 4. Air conditioner compressor pulley 5. Crankshaft pulley WARNING Be sure the ignition switch is placed in the OFF or LOCK position before servicing drive belt. The engine could rotate unexpectedly. 1. Visually inspect t ...

EVAP canister
Exploded View 1. EVAP control system pressure sensor 2. O-ring 3. EVAP canister 4. Hose clamp 5. EVAP canister purge hose 6. EVAP vent line 7. O-ring 8. EVAP canister vent control valve 9. EVAP canister vent control valve hose A. Mount to vehicle bracket Removal and Installation NOTE: ...

Nissan Versa (N17): Fender cover

Front fender

Door assembly

Other materials:

Categories