Nissan Versa (N17): B2110 Shift position/clutch interlock switch

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Security control system (SEC) / B2110 Shift position/clutch interlock switch

DTC Logic

DTC DETECTION LOGIC

NOTE: If DTC B2110 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS "DTC Logic".                   

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Shift selector lever to the P position.

2. Turn ignition switch ON and wait 1 second or more.

3. Shift selector lever to the N position and wait 1 second or more.

4. Shift selector lever to the position other than P and N, and wait 1 second or more.

5. Check DTC in Self Diagnostic Result mode of IPDM E/R using CONSULT.

Is DTC detected?

YES >> Go to SEC "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Regarding Wiring Diagram information, refer to SEC "Wiring Diagram".

1.CHECK DTC OF BCM

Check DTC in Self Diagnostic Result mode of BCM using CONSULT.

Is DTC detected?

YES >> Perform the trouble diagnosis related to the detected DTC. Refer to BCS-48, "DTC Index".

NO >> GO TO 2.

2.CHECK IPDM E/R SIGNAL CIRCUIT OPEN AND SHORT

1. Turn ignition switch OFF.

2. Disconnect IPDM E/R connector.

3. Disconnect transmission range switch connector.

4. Check continuity between IPDM E/R harness connector and transmission range switch harness connector.

5. Check continuity between IPDM E/R harness connector and ground.

Is the inspection result normal?

YES >> Replace IPDM E/R. Refer to PCS "Removal and Installation".

NO >> Repair or replace harness.

SYMPTOM DIAGNOSIS

Other materials:

A/T Fluid cooler
Cleaning Whenever the A/T is repaired, overhauled, or replaced, the A/T fluid cooler mounted in the radiator must be inspected and cleaned. Metal debris and friction material, if present, can become trapped in the A/T fluid cooler. This debris can contaminate the newly serviced A/T or, i ...

P Position warning does not operate
Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM Is the inspection result normal? YES >> GO TO 2. NO >> Perform trouble diagnosis relevant to DTC indicated. 2.CHECK DTC WITH COMBINATION METER Check that DTC is not detected with combination meter ...

Categories


© 2017-2025 Copyright www.niveguide.com
0.0067