Nissan Versa (N17): EVAP control system pressure sensor

Nissan Versa 2nd generation (N17) Service Manual / Engine / Fuel system (FL) / EVAP control system pressure sensor

Exploded View

EVAP CONTROL SYSTEM PRESSURE SENSOR

1. EVAP control system pressure sensor 2. O-ring 3. EVAP canister

Removal and Installation

NOTE: The EVAP canister system pressure sensor can be removed without removing the EVAP canister.

REMOVAL

  1. Remove the EVAP canister protector cover.
  2. Disconnect EVAP canister purge hose from EVAP canister.
  3. Disconnect EVAP control system pressure sensor.
  4. Remove EVAP control system pressure sensor and O-ring.

CAUTION: Do not reuse O-ring.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Do not reuse O-ring.

EVAP canister vent control valve

Exploded View 1. EVAP canister 2. O-ring 3. EVAP canister vent control valve 4. EVAP canister vent control valve hose Removal and Installation NOTE: The EVAP canister vent control valve can ...

Fuel level sensor unit

Disassembly and Assembly Fuel Level Sender Unit 1. Harness connectors 2. Level sending unit module 3. Fuel temperature sensor 4. Float arm assembly Disassembly NOTE: Before disassembly, not ...

Other materials:

P0720 Output speed sensor
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0720 Output Speed Sensor Circuit Under the following diagnosis conditions, the output speed sensor value is less than 100 rpm continuously for 5 seconds or ...

Fuel filler lid lock
FUEL FILLER LID LOCK : Removal and Installation REMOVAL 1. Fully open fuel filler lid. 2. Remove trunk side finisher (LH). Refer to INT "TRUNK SIDE FINISHER : Removal and Installation". 3. Release pawls (A) and remove fuel filler lid lock assembly (1) from opening. CAUTION: Be car ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0211