Exploded View

1. EVAP canister 2. O-ring 3. EVAP canister vent control valve 4. EVAP canister vent control valve hose
Removal and Installation
NOTE: The EVAP canister vent control valve can be removed without removing the EVAP canister.
REMOVAL
(A) : Lock
(B) : Unlock
CAUTION: Do not reuse O-ring.

INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Do not reuse O-ring.
EVAP canister filterExploded View 1. EVAP canister vent control valve hose 2. Canister drain hose 3. EVAP canister filter Front Removal and Installation REMOVAL Remove the EVAP canister protector cover. ...

Exploded View 1. EVAP control system pressure sensor 2. O-ring 3. EVAP canister Removal and Installation NOTE: The EVAP canister system pressure sensor can be removed without removing the E ...
Idle air volume learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume
that keeps each engine idle speed
within the specific range. It must be performed under any of the following
conditions:
Each time electric throttle control actuator or ECM is replaced.
Idle speed or ...
Stall test
Work Procedure
INSPECTION
Inspect the amount of engine oil. Replenish the engine oil if necessary.
Refer to LU "Inspection".
Drive for about 10 minutes to warm up the vehicle so that the A/T fluid
temperature is 50 to 80C (122 to
176F).
Inspect the amount of ATF. Replenish ...