Nissan Versa (N17): Fluid cooler hose

Nissan Versa 2nd generation (N17) Service Manual / Transmission & driveline / Transaxle & transmission (TM) / Fluid cooler hose

Exploded View

Removal and Installation

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for CVT fluid leakage. Refer to TM "Inspection".

ADJUSTMENT AFTER INSTALLATION

Adjust the CVT fluid level. Refer to TM "Adjustment".

Water hose

Exploded View 1. Hose clamp 2. Water hose A 3. Bracket 4. Heater thermostat 5. Water hose B 6. Water hose C 7. Water bypass pipe 8. Hose clamp 9. Heater hose 9. Water hose D A. Water outlet B. ...

PLUG

Description Replace the O-ring if oil leakage or exudes from the plug. Exploded View 1. Plug 2. O-ring 3. O-ring 4. Plug Genuine NISSAN CVT Fluid NS-3 Removal and Installation REMOVAL ...

Other materials:

Oil pan (upper) and oil strainer
Exploded View 1. Rear oil seal 2. Oring 3. Oil pan (upper) 4. Oil pump chain tensioner (for oil pump drive chain) 5. Oil pump drive chain 6. Crankshaft key 7. Crankshaft sprocket 8. Oil pump sprocket 9. Oil pump 10. Oring 11. Oring 12. Oil pan drain plug 13. Drain plug washer 14. Oil pan ...

Clutch pedal
Exploded View 1. Clutch pedal 2. Pedal stopper rubber 3. Pedal pad 4. Clip 5. Clutch interlock switch Removal and Installation REMOVAL Remove the instrument lower panel LH. Refer to IP, "Removal and Installation". Disconnect master cylinder rod end from clutch pedal. D ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.1448