Nissan Versa (N17): PLUG

Description

Replace the O-ring if oil leakage or exudes from the plug.

Exploded View

Exploded View

1. Plug 2. O-ring 3. O-ring 4. Plug Genuine NISSAN CVT Fluid NS-3

Removal and Installation

REMOVAL

Remove the plugs and O-rings.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Do not reuse O-rings.
  • Apply Genuine NISSAN CVT Fluid NS-3 to O-rings.

Inspection and Adjustment

INSPECTION AFTER INSTALLATION

Check for CVT fluid leakage. Refer to TM "Inspection".

ADJUSTMENT AFTER INSTALLATION

Adjust the CVT fluid level. Refer to TM "Adjustment".

UNIT REMOVAL AND INSTALLATION

Fluid cooler hose

Exploded View Removal and Installation Inspection and Adjustment INSPECTION AFTER INSTALLATION Check for CVT fluid leakage. Refer to TM "Inspection". ADJUSTMENT AFTER INSTALLATION ...

Transmission assembly

Exploded View 1. Transaxle assembly A : For the tightening torque, refer to TM "Removal and Installation". Removal and Installation WARNING: Do not open the radiator cap or dra ...

Other materials:

Intake manifold
Exploded View 1. EVAP canister purge volume control solenoid valve 2. Hose clamp 3. Vacuum hose 4. PCV hose 5. Hose clamp 6. Intake manifold support 7. Gasket 8. Intake manifold 9. Electric throttle control actuator 10. Gasket 11. EVAP service port A. To air duct B. To centralized underf ...

Stall test
Work Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU "Inspection". Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80C (122 to 176F). Inspect the amount of ATF. Replenish ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0183