Nissan Versa (N17): Fuel filler lid

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Fuel filler lid

FUEL FILLER LID : Removal and Installation

REMOVAL

1. Fully open fuel filler lid.

2. Remove fuel cap pin (1).

REMOVAL

3. Remove fuel filler lid screws and fuel filler lid.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, check fuel filler lid assembly open/close, lock/unlock operation.

Trunk lid opener cable

TRUNK LID OPENER CABLE : Removal and Installation REMOVAL 1. Remove trunk lid striker. Refer to DLK "TRUNK LID STRIKER : Removal and Installation". 2. Remove trunk side finisher (LH). R ...

Fuel filler opener cable

FUEL FILLER OPENER CABLE : Removal and Installation REMOVAL 1. Remove hood and fuel filler handle assembly bolts (A). 2. Disconnect fuel filler lid opener cable (2) by pulling downward and th ...

Other materials:

P0712 Transmission fluid temperature sensor A
DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0712 Transmission Fluid Temperature Sensor "A" Circuit Low Under the following diagnosis conditions, the A/T fluid temperature identified by TCM is 180C (3 ...

A-BAG Branch line circuit
Diagnosis Procedure WARNING: Always observe the following items for preventing accidental activation. Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) Never use unspecified tester or other meas ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0062