Exploded View

1. Cluster lid C 2. Hazard switch
Pawl
Removal and Installation
REMOVAL
1. Remove the cluster lid C. Refer to IP "Removal and Installation".
2. While pressing pawls, push the hazard switch to remove.
INSTALLATION
Installation is in the reverse order of removal.
Combination switchExploded View 1. Combination switch 2. Combination switch harness connector Front Removal and Installation CAUTION: Before servicing, disconnect both battery terminals and wait at leas ...

Exploded View 1. Rear combination lamp 2. Grommet Clip ...
P1715 Input speed sensor
Description
ECM receives input speed sensor signal from TCM via the CAN communication
line. ECM uses this signal for
engine control.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P1715 is displayed with DTC UXXXX, first perform the
trouble diagnosis for DTC UXXXX.
If DTC P1715 is displa ...
P2859 Clutch A pressure
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P2859
Clutch A pressuren disengagement
performance
The detection conditions continuously for 200
msec or more under the following diagnosis
conditions:- Diagnosi ...