Nissan Versa (N17): Hood lock

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Hood lock

HOOD LOCK : Removal and Installation

REMOVAL

1. Remove hood lock assembly bolts and hood lock assembly.

2. Disconnect hood lock control cable assembly (2) from hood lock assembly (1).

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

  • Be careful not to bend the cable too much, keep the radius 100 mm (3.94 in) or more.
  • Check that hood lock control cable is properly engaged with hood lock.
  • After installation, perform hood adjustment procedure. Refer to DLK "HOOD ASSEMBLY : Adjustment".
  • After adjusting, perform hood lock control inspection. Refer to DLK "Inspection".

Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation REMOVAL Remove trunk lid weatherstrip from the trunk lid opening. CAUTION: Do not pull excessively on weatherstrip. INSTALLATION 1. Working fro ...

Hood lock control cable

HOOD LOCK CONTROL CABLE : Removal and Installation REMOVAL Disconnect hood lock control cable assembly from hood lock assembly. Refer to DLK "HOOD LOCK : Removal and Installation&quo ...

Other materials:

Trunk lid
WARNING Do not drive with the trunk lid open. This could allow dangerous exhaust gases to be drawn into the vehicle. For additional information, refer to "Exhaust gas (carbon monoxide)" in the "Starting and driving" section of this manual. Closely supervise children when they are a ...

Cylinder block
Exploded View 1. Crankshaft position sensor cover 2. Crankshaft position sensor (POS) 3. Oring 4. Drain plug 5. Cylinder block 6. Oil level gauge 7. Oil level gauge guide 8. Oring 9. Knock sensor 10. Oil temperature sensor 11. Oil pressure sensor 12. Oil jet 13. Top ring 14. Second ring ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0086