TRUNK LID WEATHER-STRIP : Removal and Installation
REMOVAL
Remove trunk lid weatherstrip from the trunk lid opening.
CAUTION: Do not pull excessively on weatherstrip.
INSTALLATION
1. Working from the upper section, align weatherstrip center mark (A) with vehicle center mark (B) and install weatherstrip onto the vehicle.

2. Align the connecting point (B) of weatherstrip (2) to the center (A) of striker (1) and install as shown.

3. Make sure entire weatherstrip is firmly seated.
NOTE: Check that weatherstrip fits tightly all around the opening, especially in each corner and along the luggage rear plate.
HOOD LOCK
Exploded View

1. Secondary latch 2. Hood lock assembly 3. Hood lock control cable assembly
Clip
Torsion barTORSION BAR : Removal and Installation REMOVAL 1. Remove torsion bar clamp. 2. Support trunk lid with a suitable tool. WARNING: Bodily injury may occur if trunk lid is not supported properly wh ...

HOOD LOCK : Removal and Installation REMOVAL 1. Remove hood lock assembly bolts and hood lock assembly. 2. Disconnect hood lock control cable assembly (2) from hood lock assembly (1). INSTALLAT ...
Cold weather driving
Freeing a frozen door lock
To prevent a door lock from freezing, apply deicer
through the key hole. If the lock becomes
frozen, heat the key before inserting it into the key
hole, or use the remote keyless entry key fob or
the NISSAN Intelligent Key.
Antifreeze
In the winter when it is antic ...
Evaporative emission system
EVAPORATIVE EMISSION SYSTEM : System Diagram
EVAPORATIVE EMISSION SYSTEM : System
Description
INPUT/OUTPUT SIGNAL CHART
Sensor
Input signal to ECM
ECM function
Actuator
Crankshaft position sensor (POS)
Camshaft position sensor (PHASE)
Engine speed*1
Piston ...