Nissan Versa (N17): Torsion bar

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Torsion bar

TORSION BAR : Removal and Installation

REMOVAL

1. Remove torsion bar clamp.

2. Support trunk lid with a suitable tool.

WARNING: Bodily injury may occur if trunk lid is not supported properly when removing the torsion bars.

3. Apply a torsion bar wrench (A) to torsion bar (1) and lift torsion bar to remove it.

REMOVAL

NOTE: For torsion bar wrench, refer to the figure.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: Check trunk lid open/close operation after installation.

Trunk lid hinge

TRUNK LID HINGE : Removal and Installation REMOVAL 1. Remove harness clips (A) from trunk lid hinge (RH only) (1). 2. Remove trunk lid assembly. Refer to DLK "TRUNK LID ASSEMBLY : Removal ...

Trunk lid weather-strip

TRUNK LID WEATHER-STRIP : Removal and Installation REMOVAL Remove trunk lid weatherstrip from the trunk lid opening. CAUTION: Do not pull excessively on weatherstrip. INSTALLATION 1. Working fro ...

Other materials:

Vehicle Dynamic Control (VDC) system (if so equipped)
The VDC system uses various sensors to monitor driver inputs and vehicle motion. Under certain driving conditions, the VDC System helps to perform the following functions: Controls brake pressure to reduce wheel slip on one slipping drive wheel so power is transferred to a non slipping drive w ...

Battery
Keep the battery surface clean and dry. Clean the battery with a solution of baking soda and water. Make certain the terminal connections are clean and securely tightened. If the vehicle is not to be used for 30 days or longer, disconnect the negative (-) battery terminal cable to ...

Nissan Versa (N17): Torsion bar

Trunk lid hinge

Trunk lid weather-strip

Other materials:

Categories