Nissan Versa (N17): Horn (HRN)

Other materials:

Drive belt idler pulley
Exploded View 1. Generator bracket 2. Center shaft 3. Spacer 4. Adjusting bolt 5. Washer 6. Idler pulley 7. Plate Removal and Installation REMOVAL Remove the fender protector (RH). Remove the air duct inlet assembly. Remove drive belt. Remove the lock nut, and then remove the pl ...

Stall test
Work Procedure INSPECTION Inspect the amount of engine oil. Replenish the engine oil if necessary. Refer to LU "Inspection". Drive for about 10 minutes to warm up the vehicle so that the A/T fluid temperature is 50 to 80C (122 to 176F). Inspect the amount of ATF. Replenish ...