Removal and Installation
REMOVAL
1. Hold the inside mirror at the base and push upward to release the retainer, then remove the mirror using a suitable tool under the base of the inside mirror.
CAUTION: Do not use excessive force to remove the inside mirror. The inside mirror is inserted tightly onto the mirror base.

INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Apply Genuine Mirror Adhesive or equivalent to bonding surface of mirror base. Refer to GI "Recommended Chemical Products and Sealants".
DOOR MIRROR
Exploded View

1. Door mirror rear finisher 2. Door mirror glass 3. Door mirror corner cover
4. Front door corner finisher 5. Door mirror assembly
Pawl

DOOR MIRROR ASSEMBLY : Removal and Installation REMOVAL CAUTION: Use the following steps to disengage the door mirror corner cover from the mirror assembly. Other methods to remove the door mirr ...
Air cleaner and air duct
Exploded View
1. Clamp 2. PCV hose 3. Clamp
4. Mount rubber 5. Air duct (inlet) 6. Air cleaner body
7. Grommet 8. Air cleaner filter 9. Air cleaner cover
10. Mass air flow sensor 11. Air duct 12. Clamp
Removal and Installation
REMOVAL
NOTE:
Mass air flow sensor is removable as an assemb ...
P0846 Transmission fluid pressure
SEN/SW B
DTC Logic
DTC DETECTION LOGIC
DTC
Trouble diagnosis name
DTC detection condition
Possible causes
P0846
Transmission Fluid Pressure
Sensor/Switch B Circuit
Range/Performance
The detection conditions continuously for 5
seconds or more under the following diagn ...