Nissan Versa (N17): Intelligent key battery

Nissan Versa 2nd generation (N17) Service Manual / Body exterior, doors, roof & vehicle security / Door & lock (DLK) / Intelligent key battery

Removal and Installation

1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key.

2. Insert a suitable tool (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part.

CAUTION:

Do not touch the circuit board or battery terminal.
The key fob is water-resistant. However, if it does get wet, immediately wipe it dry.

Removal and Installation

3. Replace the battery with new one.

Battery replacement :Coin-type lithium battery (CR2025)

Removal and Installation

4. Align the tips of the upper and lower parts, and then push them together until it is securely closed.

CAUTION:

When replacing battery, keep dirt, grease, and other foreign materials off the electrode contact area.
After replacing the battery, check that all Intelligent Key functions work normally.

WITHOUT INTELLIGENT KEY SYSTEM

Other materials:

Key interlock cable
Exploded View 1. A/T shift selector assembly 2. Key interlock cable A: Key cylinder B: Lock plate C: Clip Removal and Installation CAUTION: Always apply the parking brake before performing removal and installation. REMOVAL Move the shift selector to the "N" position. Remove the s ...

Output speed sensor
Exploded View 1. Transaxle assembly 2. Output speed sensor 3. O-ring Front Genuine NISSAN CVT Fluid NS-3 Removal and Installation REMOVAL Disconnect the harness connector from output speed sensor. NOTE: Lift up the vehicle and perform the work from rear of the transaxle asse ...

Nissan Versa (N17): Intelligent key battery

Outside key antenna

Precautions

Other materials:

Categories