Description
When the mechanical key is inserted and turned into the front door lock key cylinder switch LH, the switch transmits the LOCK or UNLOCK signal directly to the BCM.
1.CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL
Check KEY CYL UN-SW, KEY CYL UN-SW in "DATA MONITOR" mode for "POWER DOOR
LOCK SYSTEM" with CONSULT. Refer to BCS"DOOR LOCK : CONSULT Function (BCM - DOOR
LOCK)". 
Is the inspection result normal?
YES >> Key cylinder switch is OK.
NO >> Refer to DLK "Diagnosis Procedure".
Regarding Wiring Diagram information, refer to DLK "Wiring Diagram".
1.CHECK DOOR KEY CYLINDER SWITCH INPUT SIGNAL

Is the inspection result normal?
YES >> Front door lock key cylinder switch LH is OK.
NO >> GO TO 2
2.CHECK DOOR KEY CYLINDER SWITCH GROUND CIRCUIT

Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace harness.
3.CHECK DOOR KEY CYLINDER SIGNAL CIRCUIT


Is the inspection result normal?
YES >> GO TO 4
NO >> Repair or replace harness.
4.CHECK DOOR KEY CYLINDER SWITCH
Check door key cylinder switch.
Refer to DLK "Component Inspection".
Is the inspection result normal?
YES >> Check intermittent incident. Refer to GI "Intermittent Incident".
NO >> Replace front door lock key cylinder switch LH.
Component Inspection
1.CHECK DOOR KEY CYLINDER SWITCH
Check front door lock key cylinder switch LH. 
Is the inspection result normal?
YES >> Key cylinder switch is OK.
NO >> Replace front door lock key cylinder switch LH.

Diagnosis Procedure Regarding Wiring Diagram information, refer to DLK "Wiring Diagram". 1.CHECK KEY SWITCH INPUT SIGNAL With CONSULT Check k ...
Excessive ABS Function operation
frequency
Diagnosis Procedure
1.CHECK START
Check front and rear brake force distribution using a brake tester.
Is the inspection result normal?
YES >> GO TO 2
NO >> Check brake system.
2.CHECK FRONT AND REAR AXLE
Make sure that there is no excessive play in the front and rear axles. Refer ...
Fuel filler opener cable
FUEL FILLER OPENER CABLE : Removal and
Installation
REMOVAL
1. Remove hood and fuel filler handle assembly bolts (A).
2. Disconnect fuel filler lid opener cable (2) by pulling downward
and then sliding cable end to the side to remove from hood and
fuel filler handle assembly (1).
3. Rem ...