Nissan Versa (N17): Map lamp

Nissan Versa 2nd generation (N17) Service Manual / Driver controls / Interior lighting system (INL) / Map lamp

Exploded View

Exploded View

1. Map lamp bulb housing 2. Bulb 3. Lens Pawl

Removal and Installation

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION: Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.

REMOVAL

1. Release lens pawls using suitable tool (A) and remove.

CAUTION: Apply protect tape (B) on suitable tool (A).

: Pawl

REMOVAL

2. Release map lamp housing pawl using suitable tool (A).

CAUTION: Apply protect tape (B) on suitable tool (A).

: Pawl

3. Disconnect the harness connector from map lamp and remove.

REMOVAL

INSTALLATION

Installation is in the reverse order of removal.

Bulb Replacement

WARNING: Do not touch bulb with your hand while it is on or right after being turned off. Burning may result.

CAUTION:

  • Do not touch the glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to the bulb.
  • Leaving the bulb removed from housing for a long period of time can deteriorate performance of the lens and reflector (causing dirt or clouding). Always prepare a new bulb and have it on hand when replacing the bulb.

MAP LAMP BULB

Removal

1. Release lens pawls using suitable tool (A) and remove.

CAUTION: Apply protect tape (B) on suitable tool (A).

Pawl

Removal

2. Remove the bulb.

Installation

Installation is in the reverse order of removal.

Push-button ignition switch illumination circuit

Description Provides the power supply and the ground to control the push-button ignition switch illumination. ...

Interior room lamp

Other materials:

Key interlock cable
Exploded View 1. A/T shift selector assembly 2. Key interlock cable A: Key cylinder B: Lock plate C: Clip Removal and Installation CAUTION: Always apply the parking brake before performing removal and installation. REMOVAL Move the shift selector to the "N" position. Remove the s ...

Output speed sensor
Exploded View 1. Output speed sensor 2. O-ring 3. Transaxle assembly Front Removal and Installation REMOVAL Remove the front LH wheel and tire. Disconnect the harness connector from output speed sensor. Remove the output speed sensor. Remove the O-ring from the output speed sens ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0054