Nissan Versa (N17): P072C Stuck in 1GR

DTC Logic

DTC DETECTION LOGIC

DTC Trouble diagnosis name DTC detection condition Possible causes
P072C Stuck in Gear 1 The following diagnosis conditions are met and the detection conditions continue for 0.5 seconds or more.

- Diagnosis condition

- Shifting is not in progress.

- Stop lamp switch OFF

- Detection conditions

- Deceleration: Less than − 0.35 G

- Gear ratio: 6% or more, or − 6% or less compared with normal gear ratio

  • 2-4 brake solenoid valve
  • Control valve assembly

DTC CONFIRMATION PROCEDURE

CAUTION:

  • "TM, "Diagnosis Procedure"" must be performed before starting "DTC CONFIRMATION PROCEDURE".
  • Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
  • Always drive vehicle at a safe speed.

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1. Start the engine.
  2. Select the D position.
  3. Drive the vehicle.
  4. Maintain the following conditions for 5 seconds or more.
  5. Check the first trip DTC.

Selector lever : 1 position

Stop lamp switch : OFF

Vehicle speed : 20 km/h (13 MPH) or more

Is "P072C" detected?

YES >> Go to TM, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.MALFUNCTION CAUSE SIMULATION TEST

Refer to GI, "Intermittent Incident".

Is the check result normal?

YES >> Replace the transaxle assembly. Refer to TM, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

P0720 Output speed sensor

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P0720 Output Speed Sensor Circuit Under the following diagnosis co ...

P072D Stuck in 2GR

DTC Logic DTC DETECTION LOGIC DTC Trouble diagnosis name DTC detection condition Possible causes P072D Stuck in Gear 2 The following diagnosis conditions are met an ...

Other materials:

Diagnosis and repair work flow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM 1. Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs). 2. Check operation condition of the function that is malfunctioning. >> ...

Inside mirror
Removal and Installation REMOVAL 1. Hold the inside mirror at the base and push upward to release the retainer, then remove the mirror using a suitable tool under the base of the inside mirror. CAUTION: Do not use excessive force to remove the inside mirror. The inside mirror is inserted tigh ...

Categories


© 2017-2026 Copyright www.niveguide.com
0.0054